iConnect is based on a simple feature which already exists in iBurst UTD, this short howto will explain how its all done. PROCEED AT OWN RISK.
First off, its not my problem if you destroy your UTD & WBS won’t feel sorry for you either.
Your UTD should be connected via ethernet for this to work, change your IP to 192.168.250.5 (in theory you could replace the 5 with anything except 10). You could also do this by adding an additional IP in the advanced section of your TCP/IP properties.
Access to the UTD is via telnet, so fire up a command shell (start, run, cmd) and type in the following:
telnet 192.168.250.10 1234
You should get a UTD prompt, if not you need to check your settings, You might have some trouble accesing the UTD through a router, its better to connect directly. once connected you should be able to find out which tower you are on, the load on that tower, how far the tower is and your signal strengh. To get this info type
rfScan debug 2
Once you are done you need to exit debug mode by typing
rfScan debug 0
Close Telnet and your shell and your all done.
Reminder: NOT MY PROBLEM IF YOU BREAK IT.